ran online private server disconnect after 20 mins

Ran online private server disconnect after 20 mins install#
Ran online private server disconnect after 20 mins driver#

The Mouse still moved, but nothing responded. It seemed to boot fine, however when I went into the file and storage manager in the Server manager software, and clicked on one of the drives shown, the system hung. 0-1 are a RAID 1 set, the other 4 (2-5) are simple drives.

Now there are 圆 2TB WD Se drives in the machine. I shut the machine down and plugged in the rest of the drive bays. Just now, Instead of proceeding to a RAID 5 setup like I had been doing before, I instead decided to experiment with a storage pool instead. Took longer this time, due to the time taken to Initialize, but otherwise completed without errors.

Ran online private server disconnect after 20 mins install#

The main difference here was that I also needed to install the RAID drivers for the windows install, and install the RAID GUI into windows and initialize the Array. Setup a RAID 1 array and performed the above install. Next I plugged in Bay 1 and switched the BIOS to RAID.

Next I Put one of the 2TB WD Se drives into the same bay and repeated the above. Next I put the same drive into the Front Trays and plugged in only bay 0 on the Back Plane and did the same install as above. BIOS was set to AHCI (no RAID) for the drives. Next I disconnected the the Back Plane and used a new SATA cable and a 500GB WD Black (new) i had sitting around and did a simple install onto this drive. I have now taken this machine through several rounds of trial and error diagnostics to try and Isolate the problem.įirst I ran Memtest 86+ v4.2 for about 36 hours. This project is at a standstill untill i can get this sorted out. It still froze at 40% with Drive 0 lit up.īIOS? RAID? MB? a Drive? or cable? Not sure where the problem lies at this point.

Ran online private server disconnect after 20 mins driver#

driver listed on supermicros site and tried them, just in case it was a driver version issue. Incidentally, on the assumption that it is a driver issue, I went back to the 3. I am starting wonder if I need to run WD Align, but the support files say it shouldn't be necessary. I am trying to use RAID 5 with 4 WD SE 2GB drives but so far no luck. Some Drive 0 is lit up, sometimes drive 3.

and the system has invariably frozen somewhere in the 'Getting Files ready for Installation (XX%) the percentage is never the same. However it invariably crashed without chance of recovery while performing the first batch of Windows updates. Once I actualy got server to install and boot properly. drivers provided by supermicro several times, each time with varied success (or failure). It is also the response I got from Supermicro tech Support.